04-07-2023 02:01 PM
I reset my ICX7150-c12p using the pinhole reset button and i am not seeing the 'configure me' network broadcasting so i can set it up. I have two R320 APs connected as well. This system was working fine up until a few days ago and now since i've reset i cannot connect at all to re-setup the entire system.
04-07-2023 02:08 PM
The only i thing i see is a 'Technical.Support-3930' network being broadcasted which just forces me to open a ticket.
04-07-2023 02:54 PM
Hi @trudappa
Greetings!!!
Thank you for contacting Lennar Home Community.
Hope you are doing well!!!
As per the case description, I could understand that you need help with the configuration of your RUCKUS setup.
Could you please let us know?
1. On your switch while it's plugged into the outlet, do you see any lights on? (Amber or green) Please let us know which lights are on. (Please refer to the below picture and share a picture of the same)
2. May I know how many Access Points are connected to the Switch? Could you please let me know the light status on the Access Points? Any of these lights are on (Please refer to the below picture and share a picture of the same)
Please help us with pictures of your ICX-7150-C12P Switch showing the status of the lights. Also, light the status of Access Points.
Before uploading the photos please log in to the RUCKUS account and you can upload the image.
Please let me know if you have any queries in this regard.
Thank you again.
Best regards,
Imran Sanadi
Lennar Home Community.