07-09-2023 12:35 PM
Hello ,
I recently purchased a Lennar SmartHome and AT&T came out and installed the BW210 modem I have trouble connecting to the switch and 2 access points I reset all devices and I see
Configure.Me 1150 but , when I click it it says “ can not connect to network
I went to laptop and entered the IP address and the username and password super / sp-admin does not work
Can I please get some help regarding this issue and thank you so much !
07-10-2023 01:35 AM
Hi Miami64
Thank you for reaching us.
Also I have mentioned link below of how to connect to switch using console cable. Please do run through below article and see if you can access the switch using console.
Link :
Please feel free to upload pic where you are encountering error or issue using below option
I hope this helps
Thanks
07-13-2023 10:38 AM
Hi Chandini ,
Please see attached picture of switch and both AP one is upstairs and one is downstairs
07-13-2023 10:45 AM
Hi @Miami64Scorpio
Greetings!!!
Thank you for the information you shared.
Could you please let us know the answers to the below queries to assist you better?
1. On your switch while it's plugged into the outlet, do you see any lights on? (Amber or green) Please let us know which lights are on. (Please refer to the below picture and share a picture of the same, showing the light status and the FULL Switch panel cable connections to the Switch ports)
2. Is your Internet Connection from the Internet Service Provider (ISP) stable and working? (You could check this by connecting to your local router Wi-Fi or from an ethernet cable from Router to a laptop/PC).
Please let us know the answers to ALL the above queries or let us know if you have any queries in this regard.
Thank you again for your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
07-13-2023 12:25 PM