I haven't been able to manage my Ruckus due to following Errors:
When used Ruckus App on my iPhone - I get "You are not connected to Unleashed network. Go to Settings?" pop up.
If I try to Log in using windows Laptop's browser (https://unleashed.ruckuswireless.com/) , I get login screen but same password doesn't work - it says "Login information is incorrect. Please try again."
If I try to change password on browser by clicking Forgot Password - I get greeted with "Password recovery is disabled Please setup your password recovery configuration firstly" message.
Factory reset is the only option we have. And it must work when we press the reset button with a paper clip on ONE connected Access Point. Once you press the reset button PWR light turns RED and you can see the configure.me.xxxx Wi-FI SSID to configure.
Please follow the below guide carefully step by step.
I have followed the steps carefully and I could see pwr led go red and come back to green then CTL led to turn green then 2.4G and 5G.
Total I tried 5 times on this AP and 4 times on the first AP since morning.
Have power cycled the Ruckus switch 3 times.
In addition I recorded the steps of resetting this one. Which I am happy to share for review over DM.
Can I request this to be escalated to another technician for review? I suspect there must be something seriously wrong on the device software.
Additionally I spent more than 2 hours climbing up and down the ladder and figuring out the wires etc etc. I appreciate if we could close this faster or if these devices are not reliable, I am happy to discard them and move on to another Hardware which can give reliability.
Apologies, Effective November’2022, ‘Ruckus Support for Lennar Homes customers will no longer be handled by phone or email or remote session. We will be exclusively supporting customers via this community forum support model only.
Please note this forum is on a best-effort support basis. We do not have escalation policies on forum.
When you press the reset button and see a red PWR light then you should see configure.me.xxxx Wi-Fi SSID to configure. Please search for configure.me.xxxx SSID and connect to the same before PWR light turns green.
I have tried again resetting the AP - the PWR button turns from red to green in about 15 seconds and I managed to check connections during that time and I don't see any configure.me.XXXX name on my wifi.
I understand the Support process change but As a customer I am at a bad combination of unusable devices and non friendly support methods. Very troublesome experience for any non tech homeowner who has to go thru this.
With my latest experiment not moving an inch towards progress - what suggestions do I have to try out before we give up on this Devices.
Since It is not showing up - I can not do any more resets unless there is any change in instructions .