Showing results for 
Search instead for 
Did you mean: 

Third incident- Ruckus router hung!

New Contributor

After two times of what I thought was a successful firmware update the router is hung again! Please see earlier posts for model info. Need help to upgrade firmware yet another time through USB. Or need help replacing the router! 


New Contributor

This is an emergency as the Ring security system is out of commission due to Ruckus router issue. 


Hi @Karupasu 


Thank you for contacting RUCKUS Lennar Home Community.

I hope you are doing well!!!

Thank you for the information you shared.

As per the case description, I understand that your RUCKUS ICX-7150-C12P Switch is stuck in boot mode.

You already tried resetting using a paper clip which is not resolving the issue permanently. At this point,  we need to perform a software recovery since it can be that the image flash is corrupted in basic words the unit is not able to boot up properly and needs to re-install the image to boot up properly.

Below is the Guide and Video Link to perform the Software recovery process:

Please refer to the below guide and Video link:

Video Link:

Please note, we must use ethernet cable (both ends RJ45 plugs) and USB to type C cable both together as described in steps 2 & 3 in the guide link.

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.


Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

New Contributor

Hello Imran : the instructions for Mac are incomplete. After I install the driver I am unable to see the driver when I enter the ls \dev\cu.* command