Ruckus not working

[Chris]

Our power went out at our home and our devices did not come back on. The internet is working but the power lights on our devices in the ceiling are not on and I don’t know how to get them on. 

[Jayavidhya]

Hi @Chris 

Greetings of the day,

Thanks for the details provided,

Based on your description it seems like your PoE is in disabled state, so please try to enable it back using the below steps.

Once you are done with the above process please try to upgrade the switch to the code 08095g, let me add the steps to enable back PoE and save the changes.

Enabling PoE:

Lennar#configure terminal
Lennar(config)#interface ethernet 1/1/1 to 1/1/12
Lennar(config-mif-1/1/1-1/1/12)#inline power
Lennar(config-mif-1/1/1-1/1/12)#write memory
Lennar(config-mif-1/1/1-1/1/12)#show inline power

Here you can see that the admin state is on, because I have enabled it back.

Here are two options to perform the upgrade to the recommended code 08095, take in consideration that like you are in an old code, the upgrade must be done twice from where you are 08061 to 08080f then from 08080f to 08095 UFI, and you will always use the image that start with SPS

How to Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

How to upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

Please let us know if you have any queries in this regard.

Best regards,

Jayavidhya

Lennar Home Community