05-12-2024 03:24 PM
Hello Lennar Home Support Team,
Ruckus ICX 7150-C12P is not working after a power outage. I have reviewed the posts within this forum and tried to resolve the issue without success.
Here is a summary of the issues:
We had a power outage, then all PoES- stopped working - no power to PoEs, and all the lights are off.
On the Ruckus ICX 7150-C12P, the power light is green and the SYS is orange. There are no other lights on the Ruckus ICX 7150-C12P.
Based on one of the posts in this form, I tried to reset the Ruckus ICX 7150-C12P. I unplugged the power, held the reset with the pin, and connected the Ruckus ICX 7150-C12P power. I released the pine after the status lights flight for a few seconds. This was repeated about 15 times, but it did not resolve the issue.
Next, I tried to perform software recovery following one of the posts in this form - https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re.... But the issue is not resolved yet. The major challenge here was finding the IP address for Ruckus ICX 7150-C12P. I scanned my network with https://www.advanced-ip-scanner.com/ but ICX 7150-C12P was not assigned an IP address. I confirmed this by scanning the network with ICX 7150-C12P plugged into power and unplugging it.
This has been going on for over a month and we need help.
Thank you
05-13-2024 07:43 AM
Hi @tgaroma
Greetings!!!
Thank you for contacting RUCKUS Lennar Home Community.
I Hope you are doing well!!!
I can see there is another post raised by you on the Lennar forum (please refer to the below link). Please follow the same post thread, I will assist you with the same.
Thank you again for understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.