RUCKUS Community Forums will be set to READ-ONLY mode starting Sunday, August 9 at 6 PM EDT / 3 PM PDT while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
08-05-2026 07:30 AM
Hello,
I have already followed the instructions in Article 000015143 and rebooted the ICX approximately 40 times, but the issue still persists.
I have the exact same problem described in the article. I followed all of the recommended troubleshooting steps, including:
Restarting the switch
Performing the software recovery
Rebooting the ICX multiple times
Unfortunately, none of these steps resolved the issue.
Could you please help me troubleshoot this further or advise on the next steps?
Thank you!
08-05-2026 07:44 AM
Hi @dmehta
Greetings!!!
Thank you for sharing the information.
Based on the troubleshooting performed, your ICX-7150-C12P Switch is stuck in boot mode, and a hard reset did not solve the issue;
As a result, this Switch unit appears to be defective and needs to be replaced through the RMA (Return Merchandise Authorization) process.
To initiate the replacement, please use the private chat option to respond so we can proceed further. For your reference, I have included a screenshot below.

Please let me know if you have any queries in this regard.
Thank you again for your patience and understanding.
Best regards,
RUCKUS | Lennar Home Community Support
08-05-2026 10:27 AM
Hi @dmehta
Greetings!
I’ve raised an RMA case and sent you a private message with the RMA details. You will receive further notifications from the RMA case.
Please check and let me know if you have any questions.
Thank you once again for your patience.
Best regards,
Yarenis Hernández
RUCKUS | Lennar Home Community Support
