cancel
Showing results for 
Search instead for 
Did you mean: 

Power is not going to AP(s) from switch

tpatte15
New Contributor

I have (2) APs in the house that are not receiving power. I have tried to factory reset the switch but seems to be getting stuck trying to reset and lights will continue to blink 10+ min.

5 REPLIES 5

Hi @tpatte15 

 

Thanks for the response.

 

If the resetting process doesn't work, we need to perform a software recovery.

 

Here is the quick guide to perform software recovery.

 

How to perform a Software recovery on an ICX7150 switch

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re...

 

Ruckus ICX Recovery Load boot code from boot monitor

https://www.youtube.com/watch?v=RHriOYYD_iI&t=7s

 

Note: after fixing the issue of the Switch been stuck in boot mode, please perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin, so perform the software recovery using the code 08090k with the upgrade image file named SPS08090k.bin, then when the switch is back to normal upgrade to the file SPS08095gufi.bin for both partitions primary and secondary.

 

1.Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

2. Upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

3. Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

 

 

Please let us know if you have any queries in this regard.

 

Best regards,

Jayavidhya

Lennar Home Community