11-18-2024 07:57 AM
I had a power outage and my switch is stuck in boot mode. I have hard reset with a paperclip over 10 times but it never gets out of boot mode, and I cannot install software following instructions on the community as I cannot access the device using tftp. IP scan returns no ruckus devices.
Solved! Go to Solution.
11-18-2024 08:44 AM
Hi @linda_nguyen
Greetings!!!
Thank you for the response and the update.
Please upload the screenshots/pictures once again on this post, as I cannot see them through the links you shared.
1. Once again, please make sure to download the zip drive for the file below & "extract all". Once it's extracted, run the file, the driver should be installed using the 2 links below.
Link 1: https://support.ruckuswireless.com/software/1414-brocade-ruckus-7150-usb-serial-driver-windows
Link 2: silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads
Once installed restart your laptop and try to locate the COM port details under 'Ports (COM & LTP)' with cables connected between the Laptop and the Switch (Refer to the below screenshot), Please check and let me know if that works.
2. The IP scan is not required for the Software Recovery process, as the Switch IP address is not needed. However, please note that the switch will not obtain an IP address since it is currently stuck in boot mode. For detailed instructions, kindly refer to the Software Recovery process carefully outlined in the link below.
Let me know if you have any queries.
Thank you again. We appreciate your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
11-19-2024 06:46 AM
Hi @wrfowler
Thank you for your response and for your patience.
Apologies for the inconvenience you've experienced. Upon checking with the internal team, we've identified that there is a technical glitch on the portal, which is preventing you from accessing the upgrade software tool. Our team is actively working on resolving the issue, but please note that it may take some time.
In the meantime, you can download the software tool directly from the following drive link and proceed as instructed in the user manual:
If you have any further questions or need assistance, please don’t hesitate to reach out.
Thank you again for your understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community
11-19-2024 10:06 AM
Imran,
Thanks for all your assistance. My switch is now upgraded to the stable release and everything is functioning well. It was a bit challenging as I had to borrow a device to get through applying the software, but it is good now. Have a wonderful day.
Bill
11-19-2024 10:32 AM
Hi @wrfowler
Thank you for the response.
Great!!! Good to know that the issue is now resolved.
We appreciate your time and patience on this case.
Thank you again for contacting RUCKUS Lennar Home Community and feel free to contact us for future queries.
Have a great day ahead!!!
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.