Lennar Home Ruckus ICX7150 routing code issue

[bindihar]

Unable to use the solutions provided in this community to get access to Ruckus console.  Please contact me to assist.

Bob

[Imran_ruckus]

Hi @bindihar 

Thank you for the response and the update.

Please follow to the below screenshot and enable Telnet then try accessing the CLI:

Once you enable Telnet try to access CLI from the MAC terminal as described below. And share the output of the commands mentioned below in this post.

If you have a MAC device, please try the below process. 

Example "open terminal":

Telnet: Example

nc 10.0.0.132 23 (Format is : nc <ip address of the switch> 23)

If you can access the Command line using Telnet should look like below prompt:

????telnet@ICX7150-12P Switch>

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable

show version

show flash

Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[bindihar]

I got part way but maybe I am supposed to put in either a password or a router #????

  

[Imran_ruckus]

Hi @bindihar 

Thank you for the response and the information you shared. 

You have executed the command correctly. There is no need of adding anything.

As you know this issue is because your switch is running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike, the Switch boots up on the other partition which may be running on a ‘Routing Code’ results in causing this issue.

As I can see from the output you shared, your Switch is booted up on the secondary partition which is running on Routing code (SPR) as highlighted in the screenshot below. 

Please Enter the below commands in CLI to fix this issue:

Note: Hit Enter to accept each command 

enable

copy flash flash secondary 

boot system flash secondary yes 

Example below: 

VIDEO LINK AS REFERENCE: https://www.youtube.com/watch?v=Eem1IBgYaWc

????telnet@ICX7150-C12-Router>enable (hit enter to accept the command) 
????telnet@ICX7150-C12-Routerr#copy flash flash secondary (hit enter to accept the command and wait: until the flash finished) 
????telnet@ICX7150-C12-Router#boot system flash secondary yes (hit enter to accept the command: the switch will reboot)

Please let me know if you have any queries in this regard.

Did I answer your queries? If yes, hit the Kudos buttons and also accept the answers as Accepted solutions.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[bindihar]

Thanks so much Imran......that worked...got it switched to the right partition.

Bob

[Imran_ruckus · Accepted solution]

Hi @bindihar 

Thank you for the response.

Great!!! Good to know that the issue is now resolved. 

We appreciate your time and patience on this case.

Did I answer your queries? If yes, hit the Kudos buttons and also accept the answers as Accepted solutions.

Thank you again for contacting RUCKUS Lennar Home Community and feel free to contact us for future queries.

Have a great weekend ahead!!!

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.