ICX 7150 stops working after power outage

[rahulmunjal]

I have a Rukus and two APs and every time there is an electricity trip the Rukus switch fails to connect to the internet and it just goes into an intermediate state where the devices keep connecting gf and disconnecting. All my devices like garage door, ring bell, switches, etc which use WiFi stop connecting. It takes a hell lot of multiple reboots of all modem, router, and switch and wait and watching for several hours or even days to stabilize the connection. I did check that the AP is on latest update but have no access to the switch itself to check the firmware version and upgrade. I see steps to connect via putty on windows but I do not have any windows machine at home (just iPads and Mac). This has been happening for about a year and I end up connecting directly to modem/router for my office work when I have to. Need help urgently to fix this situation. Thank you in advance. Let me know if any additional information is needed to understand and fix the issue.

[pinky_ruckus]

Hello @rahulmunjal ,

Thank you for the response.

From the screenshot you shared, I see that you were trying to use the IP address of the Access point instead of using the IP address of the Switch.

Could you please try accessing the CLI using the IP address of the Switch?

Once you access the IP address from the IP Scan results, to confirm that the IP address is associated with the Switch, you should observe the Switch Dashboard, which should be visible upon accessing the appropriate IP address, as illustrated in the screenshot below.

I recommend cross-checking the IP addresses listed in the IP scan results under the names "Ruckus Wireless" or "Brocade Communications" to identify the correct IP address of the Switch and proceed to access the CLI accordingly.

Please let us know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[pinky_ruckus]

Hello @rahulmunjal ,

Greetings!

This is a follow-up in reference to the case you have opened in the Ruckus Lennar Support Community.

I would like to know if you require further assistance since our last correspondence. Should you have any questions or if the status of your case has changed, please let me know by responding to this post.

Please feel free to contact if you have any further concerns regarding the same.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[rahulmunjal]

Yes I am unable to initiate the CLI as the password combinations are not working. What should be next steps?

[pinky_ruckus]

Hello @rahulmunjal ,

Greetings!

This is a follow-up in reference to the case you have opened in the Ruckus Lennar Support Community.

I would like to know if you require further assistance since our last correspondence. Should you have any questions or if the status of your case has changed, please let me know by responding to this post.

Please feel free to contact if you have any further concerns regarding the same.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[rahulmunjal]

I have the IP address of the switch. But unable to CLI into it. Trying the steps to telnet with IP address isn't working.