ICX 7150 router to switch mode

[pearcebchris]

Hi all

I purchased a physical firewall and I want it to do the routing instead of my Ruckus ICX 7150. I dug through the webui settings, but I can't figure out how to put this router into a "dumb" mode to pass traffic to the firewall

[Imran_ruckus]

Hi @pearcebchris 

Greetings!!!

Thank you for contacting RUCKUS Community forum.

Hope you are doing well!!!

Thank you for the information you shared.

Could you please confirm if this is a Lennar Home setup?

If yes, please share the screenshot showing the below information from your RUCKUS ICX-7150-C12P Switch GUI.

Please let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[pearcebchris]

Hi Imran

Yes, it's in a Lennar home. I'm not sure how to get that information you're looking for. I don't see that anywhere in the GUI

[Imran_ruckus]

Hi @pearcebchris 

Greetings!!!

Thank you for the response and the information you shared.

I will leave you a guide on how to perform an IP scanner on your local network to identify the switch IP address very easily. 

How to find my Ruckus “Devices IP address” using free applications:

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-find-my-Ruckus-Device...

You should see the Switch Dashboard as shown in the below screenshot to confirm it’s a Switch IP Address. 

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.