CommScope RUCKUS Community Forums

prap89 · ‎03-09-2024

Hello,

After a power drop, noticed connections loses from WIFI. This was attributed to ruckus and tried to follow the instructions here.https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-solve-the-routing-cod...

On running the command `“boot system flash primary yes”, primary partition never switched as it couldn't find the kernel image. Here are the logs I see when running the command -

NAND read: device 0 offset 0x0, size 0x2000000
5 ecc_errors after reading 18b8000:18b9800
iproc_nand_read_page returned 2
NAND read from offset 0 failed -22
0 bytes read: ERROR
## Loading kernel from FIT Image at 70000200 ...
Bad FIT kernel image format!
ERROR: can't get kernel image!
could not boot from primary, no valid image; trying to boot from secondary
device 0 offset 0x0, size 0xc0000
BOOTING image from Secondary

On running the `show version`, it is still on "Secondary SPR08080d".

how do I go about fixing the "primary" image and make a fix that doesn't need such fixes in future?

Imran_ruckus · ‎03-11-2024

Hi @prap89

Greetings!!!

Thank you for contacting RUCKUS Lennar Home Community.

I hope you are doing well!!!

Thank you for the information you shared.

As per the case description, I understand that your RUCKUS setup is not working after a power outage.

As you mentioned and I see from the screenshot you shared, it is a Routing code issue due to a power outage.

Please refer to the below RUCKUS Lennar Knowledge Base self-help article to troubleshoot and fix this issue.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Fixing-RUCKUS-ICX-7150-C12P-...

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

View solution in original post

CommScope RUCKUS Community Forums

ICX 7150 could not boot from primary, no valid image