ICX 7150 Not sending power through POE

[akalala]

We lost power both APs aren’t receiving power after power returned. I have Reset all items several times APs and switch. I have switched cables where possible. I have attempted reboot using coms port that didn’t accept a boot load, flash attempted but failed. Boot said invalid. Not sure what I could do here. 

[akalala]

again the Wi-Fi password is the current issue I need instructions on how to reset it. I can access the AP using a Ethernet cable only. 

[akalala]

I am not able to join using wi fi

[akalala]

 I am in unleashed

[Imran_ruckus]

Hi @akalala 

Thank you for the response and the information.

First, we should have access to Unleased Web System. Please make sure you have access to Unleashed Web. 

Please browse and login to your Unleashed account.

Select Wi-Fi Network>>Select your WLAN Network (SSID)>>Edit WLAN>>Change the password  

(Please refer to the below screenshots)

You could also create a new network WLAN SSID: Please refer to the below video-

https://www.youtube.com/watch?v=eSl_8rs1QnU

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[akalala]

 

The software is show the AP is functioning properly yet none of my devices stay connected for more than a few seconds. Also AP number is disconnected not sure how to reconnect it I have cycled power so far which didn’t do much. The new SSId was with same basic results does really connect. There is a DNS error as well