cancel
Showing results for 
Search instead for 
Did you mean: 

ICX 7150 Not sending power through POE

akalala
New Contributor

We lost power both APs aren’t receiving power after power returned. I have Reset all items several times APs and switch. I have switched cables where possible. I have attempted reboot using coms port that didn’t accept a boot load, flash attempted but failed. Boot said invalid. Not sure what I could do here. 

46 REPLIES 46

 

 

IMG_2925.jpeg

IMG_2928.jpeg

IMG_2927.jpeg

 here are the updated images

IMG_2926.jpeg

IMG_2929.jpeg

I grabbed sps0808fufi.bin I couldn’t find the sps08080hufi.bin

Hi @akalala 

Greetings!!!

Thank you for the response and the update.

As I can see from the Screenshots you shared, your Switch is now upgraded to the SPS08080f.bin Version.

Now please get the file SPS08095gufi.bin in place 08095hufi.bin (mentioned in the guide) file downloading it from the portal (Please refer to the below screenshot).

Below are the completed and pending steps:

mnz10114.bin bootrom – Completed

SPS08080f.bin – Completed

SPS08095gufi.bin Pending 

 

Please follow the below commands as mentioned in the guide as well:

“copy tftp flash <tftp ip address> SPS08095gufi.bin primary”             -    (upgrade the image)

“Show flash”                                                             -  (check the primary flash has the new code)

“Write memory”                                                                                                     -  (save the changes)

“boot system flash primary”                                            -   (boot the Switch with the new code)

After the Switch comes back, run the next final command to copy what is in the primary partition to the secondary because we need that both partitions match.

"copy flash flash secondary"   - (will copy what is in the primary)

Please let me know if you have any queries in this regard.

Thank you again for your patience.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

IMG_2934.jpeg

IMG_2931.jpeg

IMG_2932.jpeg

IMG_2933.jpeg

adding pic

Am I able to reset my Ssid password now ?