cancel
Showing results for 
Search instead for 
Did you mean: 

ICX 7150-C12P System LED Flashing Green

hardwick8
New Contributor

The system went down after a storm and won't boot back up. The green system LED continues to flash without going solid. Does anyone know how to get the router past this point when it's stuck?

Thanks,

Jeff 

2 REPLIES 2

Vásquez_Fer
Moderator
Moderator

Hi @hardwick8 

Basically, due the power outage the switch is not able to boot up properly. 

Could you please try the following steps and let us know 

1-Please try to disconnect from the Power outlet the ICX-7150 and reconnected.

2-Please try to press the reset button using a paper click or a small stick 

  1. Remove power from the switch.
  2. Press and hold the Reset button while applying power to the switch.
  3. After all the system LEDs flash amber, release the Reset button.

https://docs.commscope.com/bundle/icx7150-installguide/page/GUID-D3B5DB74-53A7-4F8D-82F9-6EB600879EE...

Video link :https://www.youtube.com/watch?v=6jHMTdo_hK4

If that does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted so in basic words the unit is not able to boot up properly and need re-install the image to boot up properly.

3-We need to access (physical) using one of the cable to the ICX-7150C12P mentioned on the below guide: 

How to console in the ICX-7150-12cp 

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...

Once we are there, we can try to boot up the unit using the following commands: 

Boot_primary or Boot_secondary 

If that step does not work Software recovery needs to be applied

Here is the guide: 

 https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-r...

 

Best Regards 

Fernando Vasquez 

MRags324
New Contributor

Hello Fernando 

I have a Ruckus R320 after the hurricane is did not want to connect.  I contacted Ruskus and they sent me a replacement.  Now that I plugged back into the ceiling to the ethernet cord it lights green but that is all.  I tried to connect wifi to Configure me but I dont have that.  All I have is the two Wifi address that came with my Hotwire connection.  My wifi name I used for this Ruckus is no longer there either.   Not sure what needs to be done as I didn't connect it when I purchased the home from Lennar.  Please help. My house is no longer a smart house.