11-14-2022 08:05 PM
The boot system is set to boot from primary but it boots automatically from secondary.
telnet@ICX7150-C12-Router#sh boot-preference
Boot system preference(Configured):
Use Default
Boot system preference(Default):
Boot system flash primary
Boot system flash secondary
telnet@ICX7150-C12-Router#sh ver
Copyright (c) 2017 Ruckus Wireless, Inc. All rights reserved.
UNIT 1: compiled on Nov 20 2018 at 00:20:22 labeled as SPR08080d
(29819448 bytes) from Secondary SPR08080d.bin
SW: Version 08.0.80dT213
Compressed Boot-Monitor Image size = 786944, Version:10.1.14T225 (mnz10114)
Compiled on Thu Nov 15 12:59:22 2018
telnet@ICX7150-C12-Router>sh flash
Stack unit 1:
NAND Type: Micron NAND 2GiB (x 1)
Compressed Pri Code size = 25968884, Version:08.0.80dT211 (SPS08080d.bin)
Compressed Sec Code size = 29819448, Version:08.0.80dT213 (SPR08080d.bin)
Compressed Boot-Monitor Image size = 786944, Version:10.1.14T225
does it need software upgrade ? Is there a bug in this one ? It boots only to router mode after power outage.
11-15-2022 04:13 AM
Hope you are doing great !
Could you please run the following commands
Enable
copy flash flash secondary ( try many times if it fails )
Boot system flash secondary yes
What this is going to do is copy the SPS image in the secondary flash by re-flashing both images in SPS which will prevent the Switch from having to use 'SPR' routing code.
How to Fix Routing code issues on Lennar Home users
Here is a guide that have a better explanation :
Best Regards
Fernando Vasquez