I lost power briefly and all my WAPs have stopped working, No power

[Pantwi]

I lost power briefly and all my WAPs have stopped working, they don't have any power. I have searched for different solutions on this forum but have not had any success so far. Please help

[Pantwi]

[Imran_ruckus]

Hi @Pantwi 

Thank you for the response and the update.

Could you please share the output of the below commands

enable 

show flash

show version

show inline power 
show interface brief

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Pantwi]

[Imran_ruckus]

Hi @Pantwi 

Thank you for the response and the information.

Please Unplug the Access Points’ Ethernet cables from the Switch panel and reboot your Switch once by performing the below commands.

enable 

reload

y

Once your Switch is up, please plug the Access Points cables back into any of the 12 ports. (Please refer to the below screenshot)

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Pantwi]

Hello!

When I pressed reload, the software keeps losing connection and crashing before I can even press y. Did it go through? Should I replug the access points?