Showing results for 
Search instead for 
Did you mean: 


New Contributor III

It looks like I am another customer dealing with issues after power outage. We've had this Lennar home for a couple of years and after every power outage we have to go through a reboot. This time however after several attempts to reboot, the system will not reboot and we have no power, no lights at all, going to either access point. To say this system in our "Smart Home" is aggravating is an understatement.


Hi @RCK 

Basically, due the power outage/ power spike the switch went to a state that we called (boot-mode) that is not able to boot up properly. 

That does not mean is broken or need to be replace 'in some cases'

1-Please try to disconnect from the Power outlet the ICX-7150 and reconnected.

2-Please try to press the reset button using a paper click or a small stick 

  1. Remove power from the switch.
  2. Press and hold the Reset button while applying power to the switch.
  3. After all the system LEDs flash amber, release the Reset button.

Video link:

If that does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted so in basic words the unit is not able to boot up properly and need re-install the image to boot up properly.

3-We need to access (physical) using one of the cables to the ICX-7150C12P mentioned on the below guide: 

How to console in the ICX-7150-12CP

Once we are there, we can try to boot up the unit using the following commands: 

Boot_primary or Boot_secondary 

If that step does not work Software recovery needs to be applied

Here is the guide how to do it :

 Video Link:

Best Regards 

Fernando Vasquez 

New Contributor III

S/n FEK3825Q2D3

New Contributor III

It is in a control panel and everything inside panel has power.