My home came with 2 Ruckus r510 Unleashed Mesh Network installed by the builder (Lennar). I'm noticing my computer even though upstairs keeps connecting to the downstairs access point and thus getting slower speeds. I also noticed that my Galaxy S8 Phone when going around the house will not auto-switch to the closer one without me turning wifi off and then on again.
I have access to the mobile APP and webUI but the settings are a bit overwhelming for what i'm used to.
Can you please advise if there is a settings I have to adjust for this? Both are running the newest firmware.
Yes, there is a way to do this. Ruckus support did this for me several years ago. They had to use the console in the ap controller to run the command. We had major problems with the Intel 6200 not roaming correctly. Usually connecting to the farthest AP from the client. I just noticed that you don't have an AP Controller. Not sure it can be done without it. I'm sorry.
I was given only a 12 port gigabit switch and these 2 access points. They work well just annoying to have to keep disconnecting when I walk up and down the stairs. I think I'm going to see if I can call a company to just run a CAT6 cable to my office so I can direct connect my desktop pc.