I reached out to Ruckus Lennar Support before November when I had a chance to speak to a customer support rep via phone and email. During the original call, the I was informed that our device was "stuck in router mode" and the easiest fix would be request a new device as ours was still covered under warranty. Doing so would just require switching out the devices and shipping the original back. The other option was to get online via TeamViewer with a rep so they can do a manual fix - this was not an option at the time since I didn’t have access to a non-Apple laptop according to the rep. Now that neither of those are an option, (1) does this mean our warranty is no longer honored? and (2) how can I fix my device to switch out of router mode? We’ve had this issue for over a while now and as someone who works fully remote, it has been a big problem. I would appreciate a quick fix.
The issue is that the switch has 2 images ( flash ) , 1 switching & 1 routing, by some power outage or reboot , can make the unit start executing the routing code 'SPR' as a preference which would do the same with a replacement of same unit.
As the unit is not damaged (hardware or software) and we have not completed the troubleshooting steps we could not proceed with a replacement of the unit.
1-We can try Factory reset the unit with the following steps :
Please try to press the reset button using a paper click or a small stick
Remove power from the switch.
Press and hold the Reset button while applying power to the switch.
After all the system LEDs flash amber, release the Reset button.
If you can access to the Command line should look like this
4-Here is a quick guide to understand how to fix the 'routing code issue' but basically you need only need to run the following commands once you are on the command line 'CLI'
Note: Hit Enter to accept each command
copy flash flash secondary
boot system flash secondary yes
ICX7150-24P Router>enable (hit enter to accept the command) ICX7150-24P Router#copy flash flash secondary (hit enter to accept the command and wait : until the flash finished ) ICX7150-24P Router#boot system flash secondary yes ( hit enter to accept the command : the switch will reboot )
How to Fix Routing code issues on Lennar Home users