07-10-2023 11:01 AM
Switch will not update firmware and when in cli it says it is in read only. Also when I try to configure ssl there is no start up config file. tried multiple times and says the same thing. when i show flash it shows "Compressed Pri Code size = 25976488, Version:08.0.80fT211 (SPS08080d.bin)
Compressed Sec Code size = 25976488, Version:08.0.80fT211 (SPR08080d.bin)
Compressed Boot-Monitor Image size = 786944, Version:10.1.15T225
" It wont take the actual image 08090f to upgrade to ufi.
07-15-2023 01:42 PM
I performed software recovery steps per the guide and executed the reload command. The above string is what i got after the reload. Why is it showing next to the versions SPR/SPS 08080d.bin?
07-17-2023 08:36 AM
Hi @Rkeiser
Greetings!!!
Thank you for the response and the information you shared.
Could you please let me know what is the light status on the Switch panel now? (Please refer to the below screenshot and share a picture of the same)
Also, please enter the below commands once you log in to CLI and share the output.
Note: Hit Enter to accept each command
enable
show version
show flash
Please let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.