AT&T Fiber Gig internet with 2 r510 APs......

[WKyPT]

I have a two story home with APs on both floors hardwired through a Lennar home.  When speed testing to gateway I am getting 993 Mbps.  When testing from AP to device I am getting around the neighborhood of 32.33Mbps to 218Mbps.   AP to AP is testing at 195.31 Mbps.  What is a realistic expectation of what I should be pulling from AP to device?  I see there is a newer firmware version, but I am running 12.145.2 and these numbers were from when the firmware was current.  

[WKyPT]

Thanks for following up Pinky. I have not had a chance to perform the Access point factory reset yet. I have been away and I have also been slightly nervous to try it. I will give it a go today and see how it goes. 

[WKyPT]

Performed AP reset as directed.  After the pain that was,  ran a speed test following. Speed from AP to device and was getting essentially the same speeds. AP to device from 200-300 Mbps. 

[pinky_ruckus]

Hello @WKyPT ,

Greetings!

Thank you for sharing the information.

From the response you shared, I understand that the reset has been performed on the AP.

At this point, we suggest you to  establish a new Wi-Fi network/SSID.

Please follow the below RUCKUS Lennar Knowledge base self-help article which will help you to create new Wi-Fi network.

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Creating-a-New-Wireless-WLAN...

Please follow the article and let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[pinky_ruckus]

Hello @WKyPT  ,

Greetings!

This is a follow-up in reference to the case you have opened in the Ruckus Lennar Support Community.

I would like to know if you require further assistance since our last correspondence. Should you have any questions or if the status of your case has changed, please let me know by responding to this post.

Please feel free to contact if you have any further concerns regarding the same.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[WKyPT]

Performed the instructions on creating a new Wi-Fi network as listed above. Still only pulling 475 Mbps off my Gig fiber network.