cancel
Showing results for 
Search instead for 
Did you mean: 

AP no PoE and Switch shows Orange for SYS and Green on PWR after Power Outage

tmsuzuki
New Contributor

Hello Ruckus Support for Lennar Homes

After a short power outage today, the Ruckus CX 7150 Switch is no longer providing PoE to the 3 APs. Additionally, the Switch is showing Orange light on SYS and Green light on PWR. 

  • The internet works fine directly from the ISP. 
  • ISP Wiress | Ethernet is functional

I followed the steps in the below thread for System Recovery

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/After-power-outage-no-WiFi-f...

 

However, I get stuck on the PuTTY when configuring the gatewayip, it says that its "not alive" after following the guide here:
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re...

Its currently just not functional and will need to re-license and everything else, but I am unable to even get to that section. 

May I have assistance on this please?

6 REPLIES 6

Hello! 

When trying to troubleshoot this morning, after a few reboots, the Switch started to work fine without me doing any configuration changes.

It seems to stay on orange when the power is abruptly turned off. But after turning it off and on multiple times, it self-fixes the issue.

Is there a safe way to turn off the switch without unplugging the switch whenever I want to remove the switch to do some troubleshooting when issues like this occurs?

For now, the original issue seems to be fixed.

Thank you so much for your support!

Hi @tmsuzuki 

Greetings!!!

Thank you for the response and the update.

Great!!! Good to know that the issue is now resolved.

Please note, this issue may happen when your ICX-7150-C12P Switch runs on an older (No-UFI) version. Usually, we suggest all the users with this issue, Upgrade their Switch to the latest stable version (UFI) to avoid these issues in the future.

To check your current running version, please help us with the output of below mentioned commands.

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable 

show version

show flash

Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.