Hi @ohabib
Hope you are doing well !
Once you have done the following command
crypto key generate ec size 384
basically what we need to know the username ands password from the Switch to add it correctly on the step 2 ( Doesn't matter the credentials of the access points )
On the Unleashed dashboard
Basically we are creating a tunnel , which we need to match the credentials accessing the Unleashed dashboard and telling it the username and password from Switch , the unleashed will try to access to Switch using those credentials and joining the ICX to the unleashed.
1-Hit Add on that dashboard
2-Put the IP address of the ICX switch (ICX-7150-C12P)
3-Username and password for Switch authentication that we created on the Switch
device(config)# username super password pass
Where the username is ’super’ and password ‘pass’
To sync the data, it will take us a while, so after a couple of minutes it should say connected
Best Regards
Fernando Vasquez
Hi Vásquez_Fer
no luck, I tried to remove the user accounts and recreate new ones for the switch. I also removed the switch from the unleashed and manually added it by Ip/user/password
it does not move from connecting state. It asked me to enter credentials for the switch .. I did and it stays connecting
is there any other relative settings in the unleashes or switch side to control the authentication ?
