05-23-2024 09:14 AM
Hi all,
I currently have an icx7550-48zp running 10.0.20T243 software. I'm trying to setup a VLAN to pass through a specific port. I've configured the port untagged for VLAN 5 but in L2 settings. Is there anything I need to do in L3 settings to allow traffic to pass.
The switch is setup on a network where i am able to SSH into and able to ping the default gateway for the VLAN I am trying to connect the port to.
05-27-2024 03:32 AM
Hello,
No, the AP is not able to pull an IP. When I plug my laptop into the switch, it's searching for network connection but doesn't find the DHCP server either.
Is there anything I need to do on the incoming port? It is currently set to default VLAN1 however there are multiple VLANs that are able to pass.
05-27-2024 03:42 AM
Hi Mario
Ack and Noted. Could you assign a static IP address to the AP and try to ping gateway IP address and DHCP server address from the AP and check if services work ?
Thanks
05-27-2024 03:51 AM
I've tried that with no result, I've also plugged and AP that was previously plugged to the vSZ bypassing the switch. The AP broadcasts the SSIDs but with no internet and the per light continues to flash, searching for an IP address
05-27-2024 09:59 PM
not there yet but sounds like you don't have dhcp forwarding set up yet:
also a config dump could help out a lot