Upgrading from 8040a/b to 8095 and later on ICX7250

[josue_jimenez_c]

Heads up!

If Upgrading from 8040a/b to 8095 and later on ICX7250 

First, go to 8080f non-UFI, (boot code and then image) reload, and then the ICX7250 8095 should be ready to go to 8095 and later.

The boot code won't show up on the "show flash" output the boot for the 8080f should be this one (spz10114 ), however after the image is loaded and once the unit reloads it will show the proper image version and boot code.

CX7250-24P Router#copy tftp flash A.B.C.D spz10114.bin bootrom

ICX7250-24P Router#Load to buffer (8192 bytes per dot)
.....................
SYNCING IMAGE TO FLASH. DO NOT SWITCH OVER OR POWER DOWN THE UNIT(65536 bytes per dot)...
............
TFTP to Flash Done.
!
!
!
ICX7250-24P Router#sh fla
Stack unit 1:
Compressed Pri Code size = 24184204, Version:08.0.40bT213 (SPR08040b.bin)
Compressed Sec Code size = 33554432, Version:08.0.40bT213 (SPR08040b.bin)
Compressed Boot-Monitor Image size = 786944, Version:10.1.06T215
Code Flash Free Space = 1613881344

ICX7250-24P Router#copy tftp flash A.B.C.D SPR08080f.bin pri
................................................................................................................................................
TFTP to Flash Done.
ICX7250-24P Router#b s f p
Are you sure? (enter 'y' or 'n'): y
!
!
CX7250-24P Router>
PS 1, Internal Power supply detected.
PS 1, Internal Power supply is up.
!
!
ICX7250-24P Router#sh fla
Stack unit 1:
Compressed Pri Code size = 29829112, Version:08.0.80fT213 (SPR08080f.bin)
Compressed Sec Code size = 33554432, Version:08.0.40bT213 (SPR08040b.bin)
Compressed Boot-Monitor Image size = 786944, Version:10.1.14T215
Code Flash Free Space = 1613869056