hi network master's, just had a unexpected issue here, im running 3 icx switch. L3 and two L2 unfortunately and strange reason my L2 went down for good as a temporay solution i used our old HP switch as L2 switch. my problem is im am not really familiar configuring this model. here is my setup
ruckus switch L3 I created a LAG uplink for HP
lag uplink dynamic id 1 ports ethe 1/2/1 port-name Uplink ethernet 1/2/1
SWI-CORE#show lag Port Link State Dupl Speed Trunk Tag Pvid Pri MAC Name 1/2/1 Up Forward Full 1G 1 Yes 254 0 903a.7227.ca50 Uplink
on switch-hp1 i created a trunk for uplink port 48 which succesfully establish the connection, however i am not sure how to configure the uplink for my switch-hp2. just wondering if you guys experience to config HP switch?
I didn't expect to see you here again. I'd like to thank you again for your help with our network issues the other day. You were truly helpful.
However, I'm still struggling with one last thing. I managed to create a trunk link to my second HP switch, but I'm not sure if I did it correctly. According to the R1 report, I'm duplicating an IP from the HP switches, which is true because that's the only way to get an IP address from the VLAN.
I think it would be straightforward if I could configure the uplink as a stackport, but unfortunately, we don't have an SFP module for this ICX switch. I hope the network will last for six weeks 😅