Trying to get management working. I would like to SSH to the device without using mgmt port. Here is what I have, Cisco Router, single cable to Ruckus switch. Router and switch are communicating, I get dhcp from the router but can't ping.
sh run Current configuration: ! ver 08.0.70dT231 ! stack unit 1 module 1 icx7650-48zp-port-management-module module 3 icx7650-100g-2port-200g-module ! vlan 1 name DEFAULT-VLAN by port spanning-tree 802-1w management-vlan default-gateway 10.0.0.1 1 ! vlan 10 name DATA by port tagged ethe 1/1/1 ! vlan 20 name VOICE by port tagged ethe 1/1/1 untagged ethe 1/1/48 ! vlan 888 by port
interface GigabitEthernet0/0/0 description trunk to XLAB LAN no ip address negotiation auto ! interface GigabitEthernet0/0/0.1 description XLAB LAN MGMT segment encapsulation dot1Q 1 native ip address 10.0.0.1 255.255.255.0 ip pim sparse-mode ! interface GigabitEthernet0/0/0.10 description XLAB LAN DATA segment encapsulation dot1Q 10 ip address 10.0.1.1 255.255.255.0 ip pim sparse-mode ! interface GigabitEthernet0/0/0.20 description XLAB Voice LAN encapsulation dot1Q 20 ip address 10.0.2.1 255.255.255.0 ip pim sparse-mode no cdp enable
Since you have management vlan defined under the vlan, you will only be able to telnet/ssh within that vlan. If you come in on a different vlan it will be denied. Your other option is to just configure a normal routing interface (VE) and then you can manage it from inbound dataports. If you have not flipped on ssh, you will need to do that on this older code:
crypto key gen (tab for options if you want something specific)
Ben Beck, RCNA, RCNI, Principal Technical Support Engineer support.ruckuswireless.com/contact-us