Help needed to configure NTP client mode in ICX7150-C12

[timothy_harryma]

Hello.  I also cannot get an ICX-7150 to sync with the time server.

This is my configuration:

SSH@xxx#sh run
Current configuration:
!
ver 08.0.95nT211
!
stack unit 1
  module 1 icx7150-24-port-management-module
  module 2 icx7150-2-copper-port-2g-module
  module 3 icx7150-4-sfp-plus-port-40g-module
!
....
!
ntp
 disable serve
 peer 192.168.74.4
 peer 192.168.74.6
 peer 10.77.25.126

The clock is set to UTC, and is within 20 seconds of the actual time.  When rebooting, this was the log entry:

Oct 29 00:45:48	informational	NTP: The system clock is not synchronized and does not have a reference configured.

I have saved the config, and reloaded the switch. These are my association and status

SSH@xxx#sh ntp s
 Clock is unsynchronized, no reference clock
 NTP server mode is disabled, NTP client mode is enabled
 NTP master mode is disabled, NTP master stratum is 8
 NTP is not in panic mode

SSH@xxx#sh ntp a
 address                                   Domain name                             Reference Clock  st  when  poll  Reach delay  offset   disp
 ~ 192.168.74.4                            None                                     INIT            16     -    64     0   0.00    0.000 15937.
 ~ 192.168.74.6                            None                                     INIT            16     -    64     0   0.00    0.000 15937.
 ~ 10.77.25.126                            None                                     INIT            16     -    64     0   0.00    0.000 15937.
* synced, # selected, + candidate, - outlayer, x falseticker, ~ configured, **More characters in domain name

I have captures from the firewall it is directly connected to showing the ntp requests and the ntp replies, but the switch does not seem to be processing the ntp replies and setting the clock.

Any ideas?