R510 AP and ICX 7150 - APs shutdown and do not power back on
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-29-2018 07:07 AM
Here is my setup:
Comporium Zipstream Gigabit fiber main box gets Ethernet from junction box in garage.
The comporium box hands out dhcp addresses and has two built in wifi (2 and 5 GHz) networks enabled.
Lan out of the comporium box goes to the ICX7150 which is connected to two R510s running via POE. Separate SSID is on the APs
I noticed the AP SSID was dropping, I went to look at the APs and sure enough no lights whatsoever.
So I pulled the plug on the ICX and waited a few minutes and plugged it back in.
After around 4 minutes the APs come back online, but then after a short time, all the lights go out again and the only thing I can do is pull the plug and power cycle the ICX.
I was able to update unleashed to the 200.6 (latest version I believe).
Beyond what I'm doing I am a bit new to the whole AP \ switch configuration world.
Any ideas as to what is causing this and what my next steps should be?
Comporium Zipstream Gigabit fiber main box gets Ethernet from junction box in garage.
The comporium box hands out dhcp addresses and has two built in wifi (2 and 5 GHz) networks enabled.
Lan out of the comporium box goes to the ICX7150 which is connected to two R510s running via POE. Separate SSID is on the APs
I noticed the AP SSID was dropping, I went to look at the APs and sure enough no lights whatsoever.
So I pulled the plug on the ICX and waited a few minutes and plugged it back in.
After around 4 minutes the APs come back online, but then after a short time, all the lights go out again and the only thing I can do is pull the plug and power cycle the ICX.
I was able to update unleashed to the 200.6 (latest version I believe).
Beyond what I'm doing I am a bit new to the whole AP \ switch configuration world.
Any ideas as to what is causing this and what my next steps should be?
20 REPLIES 20
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2018 01:02 PM
Yes. show version from cli
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2018 05:18 AM
Well well... guess I have to pay for premium support just to download the USB C to UART driver? I can't believe this.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2018 05:26 AM
You should just require a ruckus account. I don’t have premium support and can download.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2018 05:41 AM
I called 1-855-RUCKUS-1 and Ruckus added me to Lennar's Premium Support account.
Should have this sorted soon... at least I have the USB to UART Driver now!
Should have this sorted soon... at least I have the USB to UART Driver now!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2018 10:00 PM
Did you ever get this resolved? I'm having similar problems.
