cancel
Showing results for 
Search instead for 
Did you mean: 

Jumbo frame support

scott_farrand_f
New Contributor III
I'm trying to figure out how to have different MTU's defined on a 7150 or 6450 switch.

I've read that I have to enable Jumbo frames on the general configuration label and then restart the switch to enable the support.

It appears that the MTU should be configurable per interface, however, the ip mtu commands seem to be missing when in an interface (e.g. eth 1/1/1) on a 7150.

I'm guessing I'm missing something...
1 REPLY 1