In cisco, the configuration is displayed such that interface is displayed first and vlan tagging or untagging is secondary.
Is there a command in ruckus so that I check the vlan tagging based on port, especially for the show run?
Can I enter the vlan tagging after going into the interface first?
You can use something like 'show vlan brief eth 1/1/1' if you are specifically looking for vlan membership on one port.
You can use below commands to add vlans via interface .Please let us know if you are looking for this command.
int eth <>vlan-config add tagged-vlan <>
And you can use show vlan brief eth <> if you are specifically looking for vlan membership on specific port.
Zairah JaveedSr Technical Support Engineer | L2 TAC Wiredsupport.ruckuswireless.com/contact-us
COMMSCOPEnow meets next
Note: Please feel free to mark the post as ACCEPTED SOLUTIONS
Thank you for reaching us. You can use the below command to view tagging and untagged details for single port.
Example below: Here we are seeing port 1/1/1 information
SSH@7150_switch_test(config)#show vlan brief ethernet 1/1/1
Port 1/1/1 is a member of 1 VLANsVLANs 1Untagged VLAN : 1Tagged VLANs :
I hope the above information helps you