Is there a command to check vlan tagged or untagged based on port

[BusinessUser]

In cisco, the configuration is displayed such that interface is displayed first and vlan tagging or untagging is secondary.

Is there a command in ruckus so that I check the vlan tagging based on port, especially for the show run?

Can I enter the vlan tagging after going into the interface first?

[BenBeck]

You can use something like 'show vlan brief eth 1/1/1' if you are specifically looking for vlan membership on one port. 

[Zairah]

Hi @BusinessUser  

You can use below commands to add vlans via interface .Please let us know if you are looking for this command.

int eth <>
vlan-config add tagged-vlan <>

And you can use show vlan brief eth <> if you are specifically looking for vlan membership on specific port. 

Regards,

Zairah Javeed
Sr Technical Support Engineer | L2 TAC Wired
support.ruckuswireless.com/contact-us

COMMSCOPE
now meets next

Note: Please feel free to mark the post as ACCEPTED SOLUTIONS

[Chandini · Accepted solution]

Hi Businessuser1

Thank you for reaching us. You can use the below command to view tagging and untagged details for single port.

Example below: Here we are seeing port 1/1/1 information

Command:

SSH@7150_switch_test(config)#show vlan brief ethernet 1/1/1

Output:

Port 1/1/1 is a member of 1 VLANs
VLANs 1
Untagged VLAN : 1
Tagged VLANs :

I hope the above information helps you

Thanks