ICX 7150-24P corrupted flash?

[nomatch]

Switch lost it's configuration after a power outage.
During boot i am getting the following messages:

Starting kernel ...

booting with 4.4 kernel
dd cmd: UBI
Config partition mounted
UBIFS error (ubi1:0 pid 566): ubifs_recover_leb: corrupt empty space LEB 11:249856, corruption starts at 767809
UBIFS error (ubi1:0 pid 566): ubifs_scanned_corruption: corruption at LEB 11:1017665
UBIFS error (ubi1:0 pid 566): ubifs_scanned_corruption: first 8192 bytes from LEB 11:1017665
UBIFS error (ubi1:0 pid 566): ubifs_recover_leb: LEB 11 scanning failed
mount: mounting ubi1:resources on /opt failed: Structure needs cleaning
Resource partition is mounted!!
Starting TPM Infra
Group tss and User tss created
kernel.hostname = localhost
hostname set to localhost
Starting TCSD Daemon
TCSD Up and Running
dma_mem_base: 0x96000000, dma_mem_len: 0x8000000, warm_mem_base: 0x9f500000, warm_mem_len: 0xb00000
Creating TUN device
Dumping the partition's content ...
Starting the FastIron.

Any help appreciated!

[hashim_bharooc1 · Accepted solution]

Hi Nomatch,
Hope you are doing Great.

Please open a tac case to work on this issue.
Please use following link to open a TAC case:

https://support.ruckuswireless.com/contact-us

Hope this helps
Thanks
Hashim

[hashim_bharooc1 · Accepted solution]

Hi Nomatch,
Hope you are doing Great.

Please open a tac case to work on this issue.
Please use following link to open a TAC case:

https://support.ruckuswireless.com/contact-us

Hope this helps
Thanks
Hashim

[nomatch]

Hello, this was a production switch and the issue needed to be delt with asap. We RMA'd it and already have a replacement up and running.
However for the future, is there a procedure for dealing with such issue, cli commands etc.

[jijo_panangat · Accepted solution]

Hello, You may try the below procedure for recovery, This will copy a fresh image from tftp server and boot from it incase of a corrupted image.
However, Software recovery should be performed under the supervision of a Ruckus support engineer

http://docs.ruckuswireless.com/fastiron/08.0.90/fastiron-08090-upgradeguide/GUID-9B5D5A56-039D-44FB-...

Thanks
Jijo 

[hashim_bharooc1]

Hi Nomatch,

Jijo had already sent you a link with the procedure, did you check it out?

If not here it is again:

http://docs.ruckuswireless.com/fastiron/08.0.90/fastiron-08090-upgradeguide/GUID-9B5D5A56-039D-44FB-...

Hope this helps.

Thanks

Hashim