cancel
Showing results for 
Search instead for 
Did you mean: 

Any specific commands to switch to switch code from router code on 8070d?

sal_buscemi
New Contributor III
Any specific commands to switch to switch code from router code on 8070d? I somehow ended up with SPR code on primary and secondary



Stack unit 1:

  NAND Type: Micron NAND 2GiB (x 1)

  Compressed Pri Code size = 29451996, Version:08.0.70dT213 (SPR08070d.bin)

  Compressed Sec Code size = 29451996, Version:08.0.70dT213 (SPR08070d.bin)

  Compressed Boot-Monitor Image size = 786944, Version:10.1.14T225

  Code Flash Free Space = 1319104512
6 REPLIES 6

hashim_bharooc1
RUCKUS Team Member
Hey Sal,

Show version will show the version.
You have router code:
SPR08070d.bin

Sample snippet:

ICX7450-48P Router#sh ver
  Copyright (c) 1996-2016 Brocade Communications Systems, Inc. All rights reserved.
    UNIT 1: compiled on Feb 13 2019 at 18:02:28 labeled as SPR08030t
      (31768772 bytes) from Primary SPR08030t.bin
        SW: Version 08.0.30tT213
      Compressed Boot-Monitor Image size = 786944, Version:10.1.14T215 (spz10115)
  HW: Stackable ICX7450-48-HPOE
  Internal USB: Serial #: 9900615043000082
      Vendor: ATP Electronics, Total size = 1919 MB

 SPR08030t  where the third letter will say S or R.  S is for Switched and R is for Router code.
Hope this helps.
Thanks
Hashim

How do I change back to SPS - switch code?

Hi Sal, 

You have to upgrade the switch with switch code.

Regards,
Abilash PR.

Hi Sal,
Here is the link to both the codes you need a credential to access it:
https://support.ruckuswireless.com/software/1913-ruckus-icx-fastiron-08-0-70d-software-release-zip
Unzip them with directory structure use tftp server make sure you have connectivity and  run Commands:
copy tftp flash 10.176.4.25 /pub/sre/Released/ironware/FastIron/08070/08070a/ICX7150/Images/SPS08070a.bin pri

write mem
reload.
10.176.4.25  is example use your own IP address.
When you go to Switched code all your Routing Interfaces will be gone so please be aware and your Management VLAN will have to be configured with an IP address for connectivity.

Hope this helps.

Thanks
Hashim