cancel
Showing results for 
Search instead for 
Did you mean: 

SZ100 firmware upgrade

claude_karemera
New Contributor III

hello,

I am upgrading SZ100 from version  3.5 to 6, but here is an error am getting.... any hint?

{Your current system cannot be upgraded. Reason: The system cannot be upgraded because the following zone(s) will be unsupported: v3.5.1.0.419 * 2}

4 REPLIES 4

sam_evans
New Contributor III

Hi,

You cannot upgrade from 3.5 directly to version 6.0. You need to review the upgrade path. You'll need to go 3.5.x > 3.6.2 > 5.2.2 > 6.0. You can verify the upgrade path required on the support site in the documents - look for upgrade guide. 

Kind regards,

Sam 

martin_martin
Valued Contributor

Exactly what Sam mentioned, but one step to remember upgrade also ap firmware after each controller upgrade.

As with 6.0 your minimum AP firmware should be 5.2.2

Check the release notes of the versions to make sure your AP models are supported with each version.

regards

Martin

syamantakomer
Community Admin
Community Admin

Hi @claude_karemera ,

Error means there is a zone in controller who's AP firmware is not compatible to newer controller version,.

To fix this, findout the zone with specified version and upgrade it to newest available firmware as per the current controller AP firmware.


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

claude_karemera
New Contributor III

Hello,

The issue was resolved by upgrading the AP firmware.

Thanks.