cancel
Showing results for 
Search instead for 
Did you mean: 

the ZD1200 has gone down

itdept_head_me
Contributor
I have an installation , just taken over the zd1200 has gone down.
(bad FW update? ) all lights are solid
RESET->no result
F/D ->no result

I finally managed to log into one of the  R500 units & issued a
"set factory" to get the web interface back

I see:
Software Version: 10.0.0.0.1424

but i cannot configure anything else.. it all says "disabled"

how can i get the network back to functioning with a dead  ZD1200
going into the units separatly wont allow a config.

If i load "unleased" wil lthis fix teh problem & can i roll back when i get the ZD replaced?



4 REPLIES 4

abilashpr
Contributor III
Hi,

Yes, you could load the unleashed firmware on the R500s and this could be done by facotory resetting the AP and then uploading the firmware by ftp or tftp.

Regards,
Abilash PR

itdept_head_me
Contributor
but is it  "undoable" when i get hte ZD back on line?

abilashpr
Contributor III
Hi,

Yes, it's undoable; you could upload the firmwares of standalone version of the APs and when they connect to replaced ZD.

They will be able to upgrade themselves to the version on ZD.

Regards,
Abilash PR.

itdept_head_me
Contributor
Thanks.... for the Info