I have an installation , just taken over the zd1200 has gone down.
(bad FW update? ) all lights are solid
RESET->no result
F/D ->no result
I finally managed to log into one of the R500 units & issued a
"set factory" to get the web interface back
I see:
Software Version:
10.0.0.0.1424
but i cannot configure anything else.. it all says "disabled"
how can i get the network back to functioning with a dead ZD1200
going into the units separatly wont allow a config.
If i load "unleased" wil lthis fix teh problem & can i roll back when i get the ZD replaced?
