RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

Initial R710 setup Cant Connect https http or ssh

I'm configuring an R710, going through the initial setup. I factory reset the device and I can ping the default IP 192.168.0.1, however I cannot access it via the web or through SSH. There's a strong possibility that this device was once configured w...

Connecting T300 root AP to P300 point-to-point bridge backhaul

Does the connection between a T300 root AP and a P300 point-to-point backhaul require the use of a switch in an unleashed network? This seems to be the case from the specs I have seen on each unit. Our existing ZF7762 APs (yes I know they're old) l...

R500 doing DNS queries to support.ruckuswireless.com every 7 seconds?

I had a look at the DNS queries flowing through my network and noticed the ruckus device is querying DNS for support.ruckuswireless.com every 7 seconds! It gets back a CNAME of two CDN servers. Is this a configurable setting? Whis is it doing this so...

Can I use SoftGRE tunnel for set of SSIDs while using local breakout for other SSIDs in the same AP

vSZ managed R500 AP will have 4 SSIDs. 3 SSIDs will use portal authentication and softGRE tunnel to Cisco iWAG as data path. 1 SSID will use traffic local breakout. Is that possible to have this setup or should all SSIDs have either tunneled or loca...

APs restart after 1800 seconds - no connection to gateway

Still battling with this vSZ-H and i thought i had it working perfectly until the APs (R510) started to reboot with error message system rebooted because of [AP gateway lost more than 1800 seconds]. I see there's an article on this already https://s...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

1

1

1

1