Using Ruckus R700 Access Point with a Wi-Fi repeater/extender
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2021 01:29 PM
Hello,
I understand that a Wi-Fi repeater/extender is not the best way to do things, but occasionally it will solve a certain unique problem. In my set up, I have 5 Ruckus R700 Access Points. The set up procedure for the Wi-Fi zone repeater/extender is not difficult, the entire set up procedure worked perfectly with no glitches. However, when I try to connect to the OBRO WiFi extender, (has good reviews) my iPhone/iPad says "No Internet connection".
Could there be any kind of a setting that could be blocking the Ruckus Access Point from passing through data coming from the WiFi extender?
Thank you for any suggestions.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2021 02:29 PM
Hi Dan,
Check if WDS is enabled or not.
Wireless Distribution System(WDS) can be Enabled or Disabled by using the following CLI commands for an AP
- Use the command below to check if WDS is Enabled or Disabled
get wds-mode <wlan name> ( eg - rkscli:get wds-mode wlan0 )
- Use the command below to Enable or Disable WDS
set wds-mode {enable|disable} <wlan name>
( eg- rkscli:set wds-mode disable wlan0 )
NOTE: By default WDS is enabled on APs.
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

