cancel
Showing results for 
Search instead for 
Did you mean: 

Ruckus 7055 AP standalone

saleem_ankeer
New Contributor

Dears ,

kindly I wont to ask if we can configure Ruckus 7055 AP  to work as standalone  and how ?

Thank you ,

Regards ,

1 ACCEPTED SOLUTION

eizens_putnins
Valued Contributor

And by the way, recommended by David Solo 104 version doesn't support ZD7055, so don't try to use it...

I am not sure if the 100.1 is the latest, but at least it's one of the last supporting this old AP. It is always mentioned in release notes for the version, what APs are supported. Never try to load wrong model firmware to AP -- in the best case upgrade will fail, in the worst you'll brick the AP. 

View solution in original post

10 REPLIES 10

eizens_putnins
Valued Contributor

You can. Just need to reset it and load standalone image to it. It is very old AP, but still it works reliably... 

eizens_putnins
Valued Contributor

And switch ports are managable.

@eizens_putnins Thank you dear but how can I load the standalone image . 

David
New Contributor III

Hi saleem_ankeer,

you just need to connect to GUI (best to factory reset AP first) and then upload a solo version from our support portal, with this link

http://support.ruckuswireless.com/software/1017-zoneflex-solo-access-point-104-0-0-0-1347-ga-softwar...

Thanks.

David.

Labels