CommScope RUCKUS Community Forums

saleem_ankeer · ‎10-17-2021

Dears ,

kindly I wont to ask if we can configure Ruckus 7055 AP to work as standalone and how ?

Thank you ,

Regards ,

eizens_putnins · ‎10-18-2021

And by the way, recommended by David Solo 104 version doesn't support ZD7055, so don't try to use it...

I am not sure if the 100.1 is the latest, but at least it's one of the last supporting this old AP. It is always mentioned in release notes for the version, what APs are supported. Never try to load wrong model firmware to AP -- in the best case upgrade will fail, in the worst you'll brick the AP.

View solution in original post

eizens_putnins · ‎10-17-2021

You can. Just need to reset it and load standalone image to it. It is very old AP, but still it works reliably...

eizens_putnins · ‎10-17-2021

And switch ports are managable.

saleem_ankeer · ‎10-18-2021

@eizens_putnins Thank you dear but how can I load the standalone image .

David · ‎10-18-2021

Hi saleem_ankeer,

you just need to connect to GUI (best to factory reset AP first) and then upload a solo version from our support portal, with this link

http://support.ruckuswireless.com/software/1017-zoneflex-solo-access-point-104-0-0-0-1347-ga-softwar...

Thanks.

David.

CommScope RUCKUS Community Forums

Ruckus 7055 AP standalone