cancel
Showing results for 
Search instead for 
Did you mean: 

I have 25 controller managed RUCKUS 320 and I want to configure each one to a specific IP addres

Shirley
New Contributor

Hi,

I want to define each of my managed access points to a specific IP. I don't want them to use the DHCP pool of adresses. When I'm trying to define an access point, I always receive the manager IP and can't define the other 24 managed access point to define their adresses.

10x in advanced'

Shirley.

1 REPLY 1

Vineet_nejwala
Moderator
Moderator

Hi @Shirley 

What type of controller are you using ? Manually via CLI you can define a static IP using below :

set ipaddr wan <IP_address> <subnetmask> <gateway>

Note : The above command needs to be run on each AP individually 

Best Regards

Vineet