I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

[javier_eduardo_]

I had my AP R610 with the firmware Unleashed AP 200.8.10.3.243... the username super and Password sp-admin, but when the firmware was downgraded to Indoor AP 104.1.0.0.298, i can not access at the webgui with this username and password. Somebody want the correct username and password for the Indoor AP 104.1.0.0.298?

[andrew_giancol1]

Good Morning, Are you able to SSH into the AP?

[andrew_giancol1]

I think the command to turn HTTP or HTTPS back on when accessing the Ruckus CLI is set http and set https depending on what you need.
Best of luck!

[hariharan_chand]

Hi Javier,

When the AP has loaded ZoneFlex 104.x base image firmware, reboot the AP, and it will be accessible via Ethernet, at 192.168.0.1 IP address, with super/sp-admin login credentials 

Operate the AP in Standalone mode through the WebUI, or SSH to the AP and issue 'set director ip a.b.c.d' with the IP address of a ZoneDirector or 'set scg ip a.b.c.d' for a SmartZone controller, to manage the AP if desired and yes enable HTTP/HTTPS if the WebUI is not accessible

Eg:

** Ruckus R710 Multimedia Hotzone Wireless AP: xxxxxxxxxxxx

rkscli:
rkscli:
rkscli: set https enable
OK
rkscli: set http enable
OK
rkscli:

Thanks,
-Hari.

[javier_eduardo_]

Hi guys...
Thaks for your answers. With the Internet Explorer i can't access at the webgui... but i try access with the Google Chrome and i can access with the credentials super and sp-admin.