cancel
Showing results for 
Search instead for 
Did you mean: 

I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

javier_eduardo_
New Contributor
I had my AP R610 with the firmware Unleashed AP 200.8.10.3.243... the username super and Password sp-admin, but when the firmware was downgraded to Indoor AP 104.1.0.0.298, i can not access at the webgui with this username and password. Somebody want the correct username and password for the Indoor AP 104.1.0.0.298?
6 REPLIES 6

andrew_giancol1
Contributor III
Good Morning, Are you able to SSH into the AP?

I think the command to turn HTTP or HTTPS back on when accessing the Ruckus CLI is set http and set https depending on what you need.
Best of luck!

Hi Javier,

When the AP has loaded ZoneFlex 104.x base image firmware, reboot the AP, and it will be accessible via Ethernet, at 192.168.0.1 IP address, with super/sp-admin login credentials 

Operate the AP in Standalone mode through the WebUI, or SSH to the AP and issue 'set director ip a.b.c.d' with the IP address of a ZoneDirector or 'set scg ip a.b.c.d' for a SmartZone controller, to manage the AP if desired and yes enable HTTP/HTTPS if the WebUI is not accessible

Eg:

** Ruckus R710 Multimedia Hotzone Wireless AP: xxxxxxxxxxxx

rkscli:
rkscli:
rkscli: set https enable
OK
rkscli: set http enable
OK
rkscli:

Thanks,
-Hari.






javier_eduardo_
New Contributor
Hi guys...
Thaks for your answers. With the Internet Explorer i can't access at the webgui... but i try access with the Google Chrome and i can access with the credentials super and sp-admin.