in my case, I use to be standalone AP , (PPPoE, local subnet nat and route to wan )
I have to check this page
https://forums.ruckuswireless.com/ruckuswireless/topics/how-to-turn-off-mesh-recovery-island-xxxxxx-...but , it didnt work
I have try some step
just like:
1.update firmware -> Software Version:100.1.0.0.432
2.reset to factory and setup again
3.use command -> set state wlan102 down
# ok it's work ! get wlanlist , recovery-ssid is down !
# but ,when I restart R500, recovery-ssid "island-XXXX" turn up again...
what should I must to try ?
1..AP is no longer in factory default.
-> I am already setup something
2.And, AP can reach its gateway.
-> R500 is gateway
thx a lot for your reply
P.S forgive my grammar
