Solved: Factory reset of t610 - Page 2

namezys · ‎01-11-2024

I got two used T610 and want to install them in school there I have a small WiFi net on R710/R610.

With the first one, there were not any issues: factory reset, login, flash unleashed firmware

However, I can't get access to the second one at all:

it created a new WiFi SSID: island-xxxxxx (according mac address)
- I was able to connect using the serial number as WiFi password
- However, there is no DHCP server and I don't know what IP should I use
it requested an IP address from a DHCP server
if no DHCP server, he accepts pings to 192.168.0.1
all ports are close
- even 22 SSH: connections refused
- even 80/443

TCP dump:

IP 0.0.0.0.bootpc > broadcasthost.bootps: BOOTP/DHCP, Request from 18:4b:0d:27:75:40 (oui Unknown), length 548
LLDP, length 165: RuckusAP

Unleashed can not take it.

After the factory reset, nothing happened except it rebooted: the PWR indicator changed to red, then started to blink, and after releasing the button it rebooted.

I'm thinking of installing a virtual controller to proxmox.

What can I do?

namezys · ‎01-12-2024

Hi @syamantakomer

It was run using a PoE injector with a direct connection to MacBook without any access to any network. Obviously, it was taken from a working environment and it was not able to reach a controller. Also, the factory reset worked because the username and password were reset to default. However, SSH and HTTP/HTTPS ports were closed even after reset.

Finally, I was able to connect using the console port and flash unleashed using tftp. Of course, It was required open case but because no any warranty I didn't care about it.

View solution in original post