CommScope RUCKUS Community Forums

ross_halliday · 06-28-2016

Hello,I'm attempting to turn up a vSZ-D instance in my lab. I've got a pair of vSZ controllers running in a cluster, each with three interfaces (Management, Cluster, Control). The vSZ-D documentation is pretty bad, as it calls the one interface "Mana...

ross_halliday · 11-22-2017

Does the "real" SZ integrated both the "control" and the "data" into the same box? With vSZ-D nowhere in the docs does it say that the system is managed as if it were an AP by the controllers, but the APs connect to the vSZ-D as if it were a controll...

ross_halliday · 11-22-2017

Any luck with this? I'd assume that if they work using a regular vSwitch, a distributed one shouldn't be a hassle. It all looks the same to the VM

ross_halliday · 09-01-2016

One of the things I haven't gotten around to testing fully yet is the AP's interception of packets. The GRE tunnel runs a low MTU - I think around 1330 bytes - of course it's not a router, so ICMP "Too Large" messages are going to be interesting! My ...

ross_halliday · 09-01-2016

Ahhh that setting, yes. Good to hear you got it sorted out finally!

ross_halliday · 08-30-2016

Hey Eddie,Yes, it actually works! lol I was very excited. I followed the directions in the manual on how to configure the vSwitch to pass all VLANs unmolested. I think the port group is simply configured with a VLAN ID of -1 or 0 or 4096 or someth...

CommScope RUCKUS Community Forums

User Statistics

User Activity

vSZ-D Network Configuration

Re: vSZ-D Network Configuration

Re: vSZ-D Network Configuration

Re: vSZ-D Network Configuration

Re: vSZ-D Network Configuration

Re: vSZ-D Network Configuration