I have a ICX-7150 that’s stuck in routing mode and I need to get it into the switch code so I can upgrade it however I can’t serial connect to it and can’t locate an IP for the device. Any suggestions?
Well i got access to it after following another document and resetting the username process but now how do I get into managing the AP's..? All I have is this terrible UI
I had to go through the second option and restore the entire image on the system, now that I've done that the system is up but there is no access to it. I've tried the super and sp-admin combo but no luck, what would the credentials be set to?
here is the status of the system. The issue occurred after a power outage 2 years ago and I’ve lived with this ever since and finally getting to cleaning up Lennars mess.
Already tried that and then the system was flashing amber on all LEDs for 20 minutes doing nothing. Power cycled and then the system led is Amber, did it again and same result over and over.
Already tried that and then the system was flashing amber on all LEDs for 20 minutes doing nothing. Power cycled and then the system led is Amber, did it again and same result over and over.
